Nimbus Technologies

• The System Has Three Modes To Time Timer,Flicker, Clock
• Function Lock Can Be Set
• 4-digit Number Led Display, Including Decimal Point For
•  Interpretation
• Under Timing Mode It Can Be Counting Up Or Down
•  Four Units Indication Services For The Timing Mode
•  9999(Hour), 9999(Min). 99.59(Min.Sec). 99.59(Hour.Min)
• Two Output Action To Be Set: (1) Alternating Between C1 &
•  C2 (2) Output On Power-on And After Timer-on
• Simultaneous Use Of Dual Time Settings, Individual
•  Independent Output
• A Variety Of Functions Can Be Done By Transmitting External
•  Signals

• Varlous Themocouple Input selectable and RTD.
• Two-point alarm, with 22 alarm modes
• Auto/Manual tuning switchable
• Sensor Break display indiction, "oPEn"
• Function of SMART TEMPERATURE TRANSDUCER
• Program Lock can be set
• oC or oF Option
• Internally mounted Timer
• 2 pattern, include 8 ramp step and 8 soak for every pattern. can be link 2 pattern become 16 ramp step and 16 soak step
• Can be setting 6 point temperature auto-turning. varius heating circumstance be applicable.

• Two-point Alarm,Each Has 22 Alarm Modes
•  Auto/Manual Tuning Switch
•  Sensor Break Display Indication “Open”
•  Function Of Smart Temperature Transducer
•  Internally Mounted Timer
•  Function With Two Slope
•   6 Sets Of Pid Algorithm To Adopt Various Environments
•  Parameter Values Can Be Increased Or Decreased
•  May Choose Two Sets Of Output And Alarm Concurrently
• Selectable Functions For Auxiliary Power Supply In
• Dc24V And Re-transmission
• Selectable Functions For Rs485 And Host-slave Mode

DO9786T / DO9766T transmitters convert the output of a conductivity electrode with temperature compensation into a 4÷20 mA signal. The electrode input circuit is galvanically insulated against the 4÷20 mA output signal. An LCD indicator allows viewing of the process signal value and of the various parameters. The accurate design and choice of components make the instrument precise and reliable for a long working life.

Manual temperature setting If the temperature probe is not connected or if the probe is broken the measuring unit °C or °F flashes. In this case it is possible to set the temperature compensation value manually. 
Press the CAL key and the °C/°F key together; the message CAL appears at the bottom of the display.
Using the and  keys, set the temperature value corresponding to the temperature of the liquid in which you wish to measure conductivity.
Press CAL to confirm this value. The message CAL disappears.